Archived Content
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
1)The objectives of this Code are achieved
by measures, such as those described in the acceptable solutions in
Division B, that are intended to allow the plumbing system to perform the following functions (see Appendix A):
F01To minimize the risk of accidental ignition.
F02To limit the severity and effects of fire or explosions.
F20To support and withstand expected loads and forces.
F21To limit or accommodate dimensional change.
F30To minimize the risk of injury to persons as a result
of tripping, slipping, falling, contact, drowning or collision.
F31To minimize the risk of injury to persons as a result
of contact with hot surfaces or substances.
F40To limit the level of contaminants.
F41To minimize the risk of generation of contaminants.
F43To minimize the risk of release of hazardous substances.
F45To minimize the risk of the spread of disease through
communal shower facilities.
F46To minimize the risk of contamination of potable water.
F62To facilitate the dissipation of water and moisture from
the building.
F70To provide potable water.
F71To provide facilities for personal hygiene.
F72To provide facilities for the sanitary disposal of human
and domestic wastes.
F80To resist deterioration resulting from expected service
conditions.
F81To minimize the risk of malfunction, interference, damage,
tampering, lack of use or misuse.
F82To minimize the risk of inadequate performance due to
improper maintenance or lack of maintenance.
This information has been archived because it is outdated and no longer relevant.