Warning This information has been archived because it is outdated and no longer relevant.

Archived Content

Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.

9.10.13.5.(2)
ApplicationIntent
OS1OP1
ObjectiveOS1 Fire Safety
Attribution
[F03-OS1.2]
Application
Application 1: 
Frames for wired glass described in Sentence 9.10.13.5.(1) [wired glass used as closures in vertical fire separations required to have a fire-resistance rating of not more than 1 h], where the wired glass:
  • conforms to Article 9.7.3.1. [which lists various glass standards],
  • has not been tested in accordance with Article 9.10.3.1. [i.e. not tested in accordance with the test methods described in Part 3, Appendix A-9.10.3.1., or Appendix D], and
  • is not less than 6 mm thick.
This applies to buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9].
Application 2: 
This also applies to the protection of openings:
  • near unenclosed exit stairs and ramps, as stated in Sentence 9.9.4.4.(1),
  • in exterior walls of exits, as stated in Sentence 9.9.4.5.(1), and
  • near exit doors, as stated in Sentence 9.9.4.6.(1).
Top of Page
Intent
Intent 1: 
To limit the probability that wired glass will be displaced from its mounting under the stresses imposed by a fire, which could lead to the spread of fire through openings in a fire separation, which could lead to harm to persons in the area on the other side of the separation.
Top of Page