This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.20.4.1.(2) | Application | Intent |
OH1 | OS2 | OP2 | OS1 | OH4 | OS3 |
Objective | OH1 Indoor Conditions |
Attribution | |
Application | Application 1: Thickness tolerances for head and bed joints for burned
clay brick and concrete masonry units, in buildings to
which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application
of Part 9], used in:
Exceptions:
except as stated in:
|
Top of Page | |
Intent | Intent 1: To limit the probability of excessive deviation from the
optimum mortar-joint thickness required to ensure continuous support of masonry
units while maintaining adequate mortar-to-masonry-unit bond strength and
adequate compressive strength of assemblies. Where masonry
units support or are part of an environmental separator, this is to limit
the probability of:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of harm to persons.
|
Top of Page |