This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.20.8.1.(2) | Application | Intent |
OH1 | OS2 | OP2 | OS1 | OH4 | OS3 |
Objective | OH1 Indoor Conditions |
Attribution | |
Application | Application 1: Above-ground, loadbearing walls
of hollow masonry units, in buildings to which
Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application
of Part 9]:
Exceptions:
except as stated in Sentence 9.20.1.1.(2), which applies to buildings other than described above, or where the masonry
is designed for specified loads on the basis of ultimate and serviceability
limit states.
|
Top of Page | |
Intent | Intent 1: To limit the probability of localized over-stressing and
crushing of wood plates under concentrated roof or floor loads transmitted
through framing elements, which could lead to inadequate load distribution,
which could lead to over-stressing of hollow masonry units, which could lead
to cracking of such units. Where masonry units support
or are part of an environmental separator, this is to limit the probability
of:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of harm to persons.
Intent 2: To exempt situations where another means of distributing
roof and floor loads is provided from the application of Sentence 9.20.8.1.(1).
|
Top of Page |