Warning This information has been archived because it is outdated and no longer relevant.

Archived Content

Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.

9.20.9.4.(6)
ApplicationIntent
OH1OS2OP2OS1OH4OS3
ObjectiveOH4 Vibration and Deflection Limitation
Attribution
[F20-OH4] Applies to floors and elements that support floors.
Application
Application 1: 
Location and spacing of rod-type metal ties that tie together the wythes of above-ground masonry walls that consist of 2 or more wythes, in buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9]:
  • where the wall height above the foundation wall does not exceed 11 m, and
  • in which the roof or floor system above the first storey is not of concrete construction.
Exceptions: 
except:
  • for cavity walls and masonry veneer/masonry backing walls, and
  • as stated in Sentence 9.20.1.1.(2), which applies to buildings other than described above, or where the masonry is designed for specified loads on the basis of ultimate and serviceability limit states.
Top of Page
Intent
Intent 1: 
To limit the probability of:
  • concentrations of stress in areas that typically experience higher levels of lateral stress (e.g. around openings), which could lead to an inability to resist transverse or vertical loads, and
  • inadequate load distribution among the wythes of multiple-wythe masonry walls.
This is to limit the probability of cracking or buckling.
This is to limit the probability of:
  • compromised structural integrity of masonry construction,
  • where masonry construction is part of an environmental separator, the displacement or failure of required environmental separation elements, which could lead to deterioration.
For floors and elements supporting floors, this is to limit the probability of excessive movement, deflection or vibration, which could lead to negative effects on the psychological well-being of persons.
Top of Page