This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.20.11.1.(3) | Application | Intent |
OH1 | OS2 | OP2 | OS1 | OH4 | OS3 |
Objective | OH1 Indoor Conditions |
Attribution | |
Application | Application 1: Shape and fastening of anchors connecting roof or
floor assemblies to above-ground masonry walls to provide the required lateral
support, in buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9]:
Exceptions:
except:
|
Top of Page | |
Intent | Intent 1: To limit the probability that anchors will be unable to
transfer lateral loads from masonry walls to floor or roof assemblies, which
could lead to inadequate lateral stiffness of masonry walls, which could lead
to an inability to resist lateral loads or inadequate distribution of gravity
loads, which could lead to cracking or buckling. Where
masonry units support or are part of an environmental separator, this is to
limit the probability of deformation or cracking, which could lead to the
excessive deformation, displacement or failure of required environmental separation
elements.
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of harm to persons.
|
Top of Page |