This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.20.13.2.(1) | Application | Intent |
OH1 | OS2 | OP2 | OS1 |
Objective | OH1 Indoor Conditions |
Attribution | |
Application | Application 1: Corrosion resistance and compatibility with flashing
of fastening devices for flashing, in buildings to
which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application
of Part 9]:
Exceptions:
except as stated in Sentence 9.20.1.1.(2), which applies to buildings other than described above, or where the masonry
is designed for specified loads on the basis of ultimate and serviceability
limit states.
|
Top of Page | |
Intent | Intent 1: To limit the probability of premature failure of fasteners,
which could lead to the displacement of flashing, which could lead to precipitation
or meltwater ingress. This is to limit the probability
of compromised thermal performance of components intended to resist heat transfer,
which could lead to:
This is to limit the probability of:
This is to limit the probability of harm to persons.
|
Top of Page |