Warning This information has been archived because it is outdated and no longer relevant.

Archived Content

Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.

9.27.11.2.(4)
ApplicationIntent
OH1OS2OP2
ObjectiveOS2 Structural Safety
Attribution
[F20,F22-OS2.1,OS2.3]
[F20-OS2.1,OS2.3,OS2.4] [F22-OS2.3,OS2.4,OS2.5] Applies where panel-type cladding is installed to provide the required bracing.
Application
Application 1: 
Minimum thicknesses of OSB conforming to the O-1 grade and waferboard conforming to the R-1 grade applied directly to framing or over furring strips as cladding, on buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9].
Top of Page
Intent
Intent 1: 
To limit the probability that OSB cladding will not be strong enough or rigid enough.
This is to limit the probability of:
  • an inadequate resistance to accidental impact forces or wind loads, which could lead to excessive deflection, the deformation, displacement or cracking of cladding, the opening of joints, or the failure of caulking, or
  • where support spacing does not exceed 400 mm and panel-type plywood cladding is installed as bracing to satisfy Subclause 9.23.10.2.(2)(b)(i), an inability to resist lateral loads, which could lead to racking of exterior walls.
This is to limit the probability of:
  • precipitation or meltwater ingress, which could lead to deterioration, which could lead to the structural failure of exterior walls or of elements supported or protected by exterior walls,
  • falling cladding elements, or
  • where panel-type cladding is installed as bracing to satisfy Subclause 9.23.10.2.(2)(b)(i):
    • structural failure, or
    • the excessive deformation, displacement or failure of required environmental separation elements, which could lead to deterioration, which could lead to compromised structural integrity of exterior walls or of elements supported or protected by exterior walls.
This is to limit the probability of harm to persons.
Top of Page