This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.28.4.1.(2) | Application | Intent |
OH1 | OS2 | OS1 | OS3 | OP1 |
Objective | OP1 Fire Protection of the Building |
Attribution | |
Application | Application 1: Corrosion resistance of woven or welded wire mesh
supporting stucco, on buildings to which Part 9
applies [see Sentence 1.3.3.3.(1) of Division A for application of Part
9]. |
Top of Page | |
Intent | Intent 1: To limit the probability of excessive corrosion, which could
lead to inadequate support for stucco or swelling of woven or welded wire
mesh, which could lead to delamination, disintegration or cracking under gravity,
wind or impact loads, or freeze-thaw stresses. Where stucco
is applied to masonry chimneys, this is to limit the probability of precipitation
or meltwater ingress, which could lead to the premature failure of chimney
liners, which could lead to the escape of heat or flames, which could lead
to the ignition of combustible building components, which could lead to damage
to the building. [See intent for Sentence 9.21.4.6.(1).]
|
Top of Page |