This information has been archived because it is outdated and no longer relevant. This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.29.6.2.(2) | Application | Intent |
| + |
| Application | Application 1: Maximum depth of grooves in grooved plywood interior
wall and ceiling finishes, where the grain of the face ply is at right angles
to the supporting members and where the thickness of plywood exceeds the value
shown in Table 9.29.6.1. by an amount equal to not less than the
depth of penetration of the grooves into the plies below the face ply, in buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9]. |
| Top of Page | |
| Intent | Intent 1: To exempt from the application of Sentence (1) plywood finishes that are supported at right angles to the
face ply, where the grooves will not weaken the plywood finish more than grooves
conforming to Sentence (1). |
| Top of Page |