This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.29.6.3.(1) | Application | Intent |
OS2 | OS1 | OH1 | OP2 |
Objective | OH1 Indoor Conditions |
Attribution | |
Application | Application 1: Type, minimum length and maximum spacing of nails
used to fasten plywood interior wall and ceiling finishes, in buildings to
which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application
of Part 9].
Exceptions:
except where staples providing equivalent lateral resistance are
used.
|
Top of Page | |
Intent | Intent 1: To limit the probability of inadequate support for plywood
interior finishes, which could lead to an inability to resist expected impact,
gravity or lateral loads. Where interior finishes support
or serve as required environmental separation elements, this is to limit the
probability of the deformation or detachment of interior finishes, which could
lead to the failure of required environmental separation elements, which could
lead to:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of harm to persons.
|
Top of Page |