This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.29.8.3.(1) | Application | Intent |
OS2 | OS1 | OH1 | OP2 |
Objective | OS2 Structural Safety |
Attribution | |
Application | Application 1: Minimum shank diameter, type, and minimum penetration
of nails used to fasten insulating fibreboard sheet interior wall and ceiling
finishes, in buildings to which Part 9 applies
[see Sentence 1.3.3.3.(1) of Division A for application of Part 9].
|
Top of Page | |
Intent | Intent 1: To limit the probability of inadequate support for fibreboard
interior finishes, which could lead to an inability to resist expected impact,
gravity or lateral loads. This is to limit the probability
of the deformation or detachment of interior finishes, which could lead to:
This is to limit the probability of harm to persons.
|
Top of Page |