This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.3.1.1.(1) | Application | Intent |
OS2 | OP2 | OH1 | OH4 | OS3 | OS1 |
Objective | OH1 Indoor Conditions |
Attribution | |
Application | Application 1: Design, mixing, placing, and testing of cast-in-place
concrete that is not required to be reinforced that is used in:
This applies to buildings to
which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application
of Part 9].
Exceptions:
except as stated in Sentence 9.3.1.1.(2), which applies to
unreinforced site-batched concrete.
|
Top of Page | |
Intent | Intent 1: Where concrete supports or is used in the walls of chimneys
or fireplaces, to limit the probability of the inadequate performance or premature
failure of concrete under expected environmental or structural loads, which
could lead to the failure of these walls. This is to limit
the probability of the leakage of combustion products, which could lead to
negative effects on the air quality of indoor spaces.
This is to limit the probability of harm to persons
Intent 2: Where concrete supports or is used in an environmental separator,
to limit the probability of the inadequate performance or premature failure
of concrete under expected environmental or structural loads. This
is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of harm to persons.
|
Top of Page |