This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.20.17.5.(2) | Application | Intent |
OS2 | OP2 | OH4 | OS3 |
Objective | OS3 Safety in Use |
Attribution | |
Application | Application 1: Minimum size of ledger boards supporting floor joists
on the side of flat insulating concrete form walls not in contact with the
ground, in buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9], where:
Exceptions:
except as stated in Sentence 9.20.1.1.(2), which applies to
insulating concrete form walls other than those described above, or where
the walls are designed for specified loads on the basis of ultimate and serviceability
limit states.
|
Top of Page | |
Intent | Intent 1: To limit the probability of inadequate end support for floor
joists, which could lead to an inability to resist expected gravity loads,
which could lead to the excessive movement, deformation or failure of floor
assemblies. This is to limit the probability of:
For floors and elements supporting floors, this is to limit the
probability of persons losing their balance, tripping or falling, which could
lead to harm to persons.
|
Top of Page |