This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.20.17.6.(2) | Application | Intent |
OS2 | OP2 | OH1 |
Objective | OS2 Structural Safety |
Attribution | |
Application | Application 1: Placement and embedment of anchor bolts for the attachment
of roof framing supported on the top of flat insulating concrete form walls
not in contact with the ground, in buildings to
which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application
of Part 9], where:
Exceptions:
except as stated in Sentence 9.20.1.1.(2), which applies to
insulating concrete form walls other than those described above, or where
the walls are designed for specified loads on the basis of ultimate and serviceability
limit states.
|
Top of Page | |
Intent | Intent 1: To limit the probability of the improper placement or insufficient
embedment of anchor bolts, which could lead to anchor bolts pulling out, which
could lead to the roof framing becoming detached from the insulating concrete
form walls, which could lead to an inability to resist expected gravity and
lateral loads. This is to limit the probability of compromised
structural integrity, which could lead to:
This is to limit the probability of harm to persons.
|
Top of Page |