This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.26.3.1.(3) | Application | Intent |
OS2 | OH1 |
Objective | OH1 Indoor Conditions |
Attribution | |
Application | Application 1: Slopes for profiled metal roof cladding systems specifically
designed for low-slope applications for roofs that have lower slopes than
the minimum slopes required by Table 9.26.3.1., on buildings to
which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application
of Part 9]. |
Top of Page | |
Intent | Intent 1: For minimum slope requirements, to limit the probability
of an insufficient slope of the roof or construction that serves as a roof,
which could lead to inadequate drainage or water pooling, which could lead
to:
This is to limit the probability of the premature
failure of roofing, which could lead to precipitation or meltwater ingress.
This is to limit the probability of:
This is to limit the probability of:
This is to limit the probability of harm to persons.
Intent 2: To supersede the application of Sentence 9.26.3.1.(1) to
allow lower slopes where roofing material specifically designed for lower
slopes will be used. |
Top of Page |