This information has been archived because it is outdated and no longer relevant. This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.29.5.9.(1) | Application | Intent |
| OS2 | OP2 | OH1 | OS1 | OP1 |
| Objective | OS2 Structural Safety |
| Attribution | |
| Application | Application 1: Maximum spacing of screws in single-layer installations
of gypsum board interior ceiling finishes on wood furring or framing, in buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9].
Exceptions:
except as stated in Sentence 9.29.5.9.(2), which applies to
perimeter fastening of ceiling sheets that are supported by the wall sheets
around the perimeter of the ceiling.
|
| Top of Page | |
| Intent | Intent 1: To limit the probability of inadequate support for gypsum
board, which could lead to an inability to resist expected gravity loads.
This is to limit the probability of the deformation or detachment
of interior finishes, which could lead to:
This is to limit the probability of harm to persons.
|
| Top of Page |