This information has been archived because it is outdated and no longer relevant. This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.28.2.2.(1) | Application | Intent |
| OH1 | OS2 | OS1 | OS3 | OP1 |
| Objective | OP1 Fire Protection of the Building |
| Attribution | |
| Application | Application 1: Types and characteristics of aggregate for stucco,
on buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9]. |
| Top of Page | |
| Intent | Intent 1: To limit the probability of excessive shrinkage or inadequate
compressive strength, bond strength or paste-to-aggregate bond strength, which
could lead to the delamination or cracking of stucco under gravity, wind or
impact loads, or freeze-thaw stresses. Where stucco is
applied to masonry chimneys, this is to limit the probability of precipitation
or meltwater ingress, which could lead to the premature failure of chimney
liners, which could lead to the escape of heat or flames, which could lead
to the ignition of combustible building components, which could lead to damage
to the building. [See intent for Sentence 9.21.4.6.(1).]
|
| Top of Page |