This information has been archived because it is outdated and no longer relevant. This information has been archived because it is outdated and no longer relevant.
Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.
9.28.3.2.(1) | Application | Intent |
| OH1 | OS2 | OS1 | OS3 | OP1 |
| Objective | OS3 Safety in Use |
| Attribution | |
| Application | Application 1: Minimum shank and head diameter of nails for stucco
lath and reinforcing, on buildings to which Part
9 applies [see Sentence 1.3.3.3.(1) of Division A for application of
Part 9]. |
| Top of Page | |
| Intent | Intent 1: To limit the probability of the shear failure or withdrawal
of nails, which could lead to inadequate support for stucco lath or reinforcing,
which could lead to delamination or cracking under gravity, wind or impact
loads, or freeze-thaw stresses. Where stucco is applied
to masonry chimneys, this is to limit the probability of precipitation or
meltwater ingress, which could lead to the premature failure of chimney liners,
which could lead to the leakage of carbon monoxide gas into living space,
which could lead to the acute poisoning or asphyxiation of persons.
|
| Top of Page |