Warning This information has been archived because it is outdated and no longer relevant.

Archived Content

Information identified as archived on the Web is for reference, research or recordkeeping purposes. It has not been altered or updated after the date of archiving. Web pages that are archived on the Web are not subject to the Government of Canada Web Standards. As per the Communications Policy of the Government of Canada, you can request alternate formats on the "Contact Us" page.

9.13.2.4.(3)
OH1OS2
ObjectiveOH1 Indoor Conditions
Attribution
[F40-OH1.1] Applies where dampproofing materials are installed to control the infiltration of soil gas.
Application
Application 1: 
Removal of projections and filling of depressions on the exterior of insulating concrete form walls that are in contact with the ground, where the ground level outside is higher than the ground level inside, in buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A for application of Part 9].
Exceptions: 
except as stated in:
  • Sentence 9.13.3.1.(1), which applies to foundation walls that are subject to hydrostatic pressure, and
  • Sentence 9.13.4.1.(2), which applies to the control of the infiltration of soil gas in
    • garages,
    • unenclosed portions of buildings served by walls or roofs, and
    • buildings located where soil gas is at a sufficiently low concentration as to not constitute a hazard.
Top of Page
Intent
Intent 1: 
To limit the probability of an inadequate substrate, which could lead to discontinuity in the dampproofing, which could lead to an inadequate resistance to moisture transfer from the ground.
This is to limit the probability of:
  • the ingress of moisture from the ground, or
  • compromised thermal performance of components intended to provide resistance to heat transfer.
This is to limit the probability of:
  • an inadequate control of the temperature of interior spaces, relative humidity, or water ingress and accumulation,
  • the generation of pollutants from biological growth or from materials that become unstable on wetting, or
  • deterioration, which could lead to compromised integrity of the walls.
This is to limit the probability of:
  • negative effects on the air quality of indoor spaces,
  • the inadequate thermal comfort of persons, and
  • contact with moisture.
This is to limit the probability of harm to persons.
Intent 2: 
Where dampproofing materials are installed to control the infiltration of soil gas, to limit the probability of an inadequate substrate, which could lead to discontinuity in the dampproofing, which could lead to the infiltration of soil gas, which could lead to negative effects on the air quality of indoor spaces, which could lead to harm to persons.
Top of Page