Intent 1:
To limit the probability of insufficient strength,
which could lead to an inability to resist expected gravity loads,
which could lead to the excessive sagging of gypsum board.
This is to limit the probability of the deformation or detachment
of interior finishes, which could lead to:
- the excessive deformation, displacement or failure of
environmental separation elements (such as insulation), which could
lead to deterioration, which could lead to compromised structural
integrity of the assembly, or
- where interior finishes contribute to the required bracing
or lateral support for studs, the buckling or racking of walls, which
could lead to structural failure.
This is to limit the probability of harm to persons.